Surveillance Camera Installation Process

1. The rated voltage of the wire used for monitoring cameras should be greater than the working voltage of the line; the insulation of the wire should conform to the installation method of the line and the environmental conditions of the laying. The cross-sectional area of the wire should meet the requirements of power supply and mechanical strength.

2. When wiring, try to avoid wires with joints. Except for the use of joints, the joints of the camera must be crimped or welded, and the wire connections and branches should not be subjected to mechanical force. The wires going through the tube must not have joints under any circumstances. If necessary, put the joints on the probe terminals of the junction box as much as possible.

3. The wiring should be installed horizontally or vertically in the building. The wiring should be protected by casing (plastic or iron pipe, selected according to the technical requirements of indoor piping). The ceiling wiring can be made of metal hose, but it needs to be fixed securely and beautifully.

4. The signal line cannot be parallel to the high-power power line, nor can it be worn in the same tube. If it is limited by the environment, the parallel wiring should be kept away from more than 50cm.

5. The AC power supply of the alarm control box should be routed separately. The camera should not be placed in the same tube as the signal line and the low-voltage DC power supply line. The installation of the AC power supply line should meet the electrical installation standards.

6. The wiring from the alarm control box to the ceiling needs to be managed into the wall or protected by iron pipes to improve the anti-destructive performance of the anti-theft system.

7. There are two types of conduit wiring: bright and dark. The piping of the camera is required to be horizontal and vertical, neat and beautiful.